Most of the parts we use operate at 3.3volts, but we still run into a lot of old 5volt stuff, and an occasional 2.5volt or 1.8volt part. This post explains how to use the Bus Pirate’s open collector ...

Instant Data Capture, Device Fingerprinting, and First-of-Its-Kind Malformed Message Detection and Capture Enable Unmatched Diagnostic Capabilities for Cybersecurity and Maintenance Teams Arlington, ...

Tomboy is an open source note-taking application that integrates with the GNOME desktop environment. The recent Tomboy 0.8.0 release, which was included in GNOME 2.20, offers a new D-Bus programming ...

We’re always excited to get a new chip or SIM card to interface, but our enthusiasm is often dampened by the prototyping process. Interfacing any chip usually means breadboarding a circuit, writing ...

The 74ALVT16823 is an 18-bit bus-interface D-type flip-flop with reset and enable and 3-state outputs. This device is intended to eliminate the extra packages required to buffer existing registers and ...

MIPI I3C reduces energy consumption to transfer 1 kB by about 5× to 18× compared with legacy I2C. MIPI I3C supports options for higher-performance, high-data-rate modes that can provide speeds in ...

For PCI bus interfacing, the OX16PC1952 brings together a PCI interface, two high performance serial channels, and a parallel port in one compact, 128-pin TQFP package. This integrated bridge device ...

Ron Press is the technical marketing manager of the Design for Test products at Mentor Graphics. The 20-year veteran of the test and DFT industry has presented seminars on DFT and test throughout the ...